![]() forum/ccds-dslrs/567mm-16bit.htmlīut I used an official build that I thought would avoid it because “This rule is installed when you install the PPA along with other rules per camera manufacturer. The problem looks similar to the one reported in Nightly builds, just updated: Kstars version 3.3.6 Build: My system: Rock64 running Ubuntu(Armbian) Indi Ekos, built using the download instructions on Ubuntu So it looks like a buffer type problem, but I could not see anything in the INDI control panel. If I set the image capture to 8 bit, it all works, but only after system reboot. Of course the file size of my new camera is much larger. I was previously using an ASi178MC, also 14 bit, and capturing a 16 bit, doing 60 images per session with no problem. If the former, use longer exposure times. The GREEN pixels have the lowest brightness while the BLUE pixels have the. When I look at the ZWO ASI294MC Pro's BIAS frames, and stretch it, I can see the bayer grid pattern very clearly. 8 reducer and the ASI294 MC PRO and ASAIR with L-Extreme filter using the mosaic functionality of Astro Pixel Processor. Being a DSLR user till recently, I'm used to seeing the raw, bayered, stretched BIAS frame to be an image full of random noise with no discernible patterns. ![]() Equipment: 80mm APO and the ASI183 MC PRO with the wider view of the 80mm with a. The ASi294MC is a 14 bit system, but 16 bit images preserve all the data. Two potential issues that could cause banding on this camera are 1) too short exposures, and not getting enough signal to get off the noise floor and 2) using bias frames of super-short exposures, as the signal is random at short exposures (like under. Date/Time of photo: December 2021-February 2022. If I stop and restart EKOS and add a new sequence it still hangs. If I reset and restart the sequence it continues to hang. In the example I logged, the system freezes after 7, it loops taking more images, but not downloading them. I can download some 16bit images but then after a variable number, no further images are downloaded and I need to reboot the system to unfreeze it. ( I used 5 sec lights but the effect is the same) First time after 17 images, now just trying with logs after 7. However when I try it, the system stalls. My normal sequence is 60 x 60 sec lights. (this is similar to the zwo-1600mm-16bit topic below, but I am using an "official" build) The following table provides a comparison of the differences between the ASI294 and ASI1600: USB 3. I have a problem taking 16 bit images with my new ASI129MC-Pro.
0 Comments
Leave a Reply. |